Efficient preconditioners for Radau-IIA time discretization of space fractional diffusion equations

Numerical Algorithms - This paper is concerned with the construction of efficient preconditioners for systems arising from implicit Runge-Kutta time discretization methods for one-dimensional and...     

Noninvasive Temperature Measurement in Dental Materials Using Nd3+, Yb3+ Doped Nanoparticles Emitting in the Near Infrared Region

In this work, the application of near infrared (NIR)-emitting NaYbF₄:1%Tm³⁺@NaLuF₄:30%Nd³⁺ core–shell nanoparticles is reported for noninvasive probing and monitoring the temperature during photopolymerization of dental materials. When excited at 808 nm, the synthesized nanoparticles emit NIR photoluminescence (PL) with two distinctive peaks at 865 and 980 nm which correspond to radiative transitions from the doped Nd³⁺ and Yb³⁺ ions, respectively. Luminescence intensity ratio between these two bands is found to vary with temperature due to temperature-dependent electronic excitation energy transfer between Nd³⁺ and Yb³⁺ ions at the core/shell interface. This finding allows luminescence ratiometric evaluation of the in situ temperature during photopolymerization of resin cement (doped with nanoparticles) in a veneer placement procedure. In addition, the NIR emission also enables PL imaging of the distribution of the adhesive under the veneer. The results highlight that rare-earth ions–doped nanoparticles with both excitation and emission in the NIR spectral range are advantageous for both PL-based nanothermometry and imaging due to the reduced attenuation of NIR light by dental ceramics.     

Rational design of perfluorinated sulfonic acid ionic sieve modified separator for high-performance Li-S battery

Journal of Solid State Electrochemistry - Practical application of Li-S battery is limited by the fast capacity decay and low coulombic efficiency caused by the shuttling phenomenon. Modification...     

In-situ SiN combined with etch-stop barrier structure for high-frequency AlGaN/GaN HEMT

The etch-stop structure including the in-situ SiN and AlGaN/GaN barrier is proposed for high frequency applications.The etch-stop process is realized by placing an in-situ SiN layer on the top of the thin AlGaN barrier.F-based etching can be self-terminated after removing SiN,leaving the AlGaN barrier in the gate region.With this in-situ SiN and thin barrier etch-stop structure,the short channel effect can be suppressed,meanwhile achieving highly precisely controlled and low damage etching process.The device shows a maximum drain current of 1022 mA/mm,a peak transconductance of 459 mS/mm,and a maximum oscillation frequency(fmax)of 248 GHz.     

周期性管柱信道的声波通信技术研究综述

井下声波通信技术利用周期性管柱信道实时传输声波数据，相比于其他通信方式，具有适应性好、复杂度低、传输效率高等优点，在随钻地质导向、油水井监测等方面有广阔的应用前景，是发展智能油田的关键技术之一。本文主要综述上世纪90年代以来关于信道物理模型、信道容量、声信号调制与接收方法等关键问题的研究历程，并对通信系统的设计要点与国内外相关产品的现场应用进行梳理，为后续的技术改进提供依据。     

o-Trityl phenoxy-imino vanadium (III) complexes: synthesis,characterization, and catalysis on ethylene (co)polymerization

Several phenoxy-imine ligands bearing o-trityl group in phenoxy moiety RN=CHArOH (Ar = C₆H₂(CPh₃)^tBu, R = 2,6-Me₂C₆H₃ ( L ₁ H ); 2,6-ⁱPr₂C₆H₃ ( L ₂ H ); 3,5-(CF₃)₂C₆H₃ ( L ₃ H ); 3,5-(OMe)₂C₆H₃ ( L ₄ H ); CHPh₂ ( L ₅ H ); CPh₃ ( L ₆ H )) were synthesized and characterized by¹H NMR and ¹³C NMR spectroscopy. The vanadium complexes based on these ligands LVCl₂(THF)₂ ( 1–6 ) were synthesized via conventional transmetalation reaction in moderate to high yields. Complexes 1–6 were fully characterized by FT-IR, elemental analyses and the molecular structures of 1 , 2 ·H₂O, (2 ·H₂O ) ₂ (μ-Cl) ₂ , 4 , and 5 were confirmed by X-ray crystallographic analysis in which the six-coordinated vanadium centers are in a typical octahedral geometry. Upon activation with Et₂AlCl in toluene, complexes 1–6 showed high activities in ethylene polymerization affording polymers with moderate molecular weight (5.9–11.8 × 10⁴ Da). Moreover, in hexane or CH₂Cl₂, 1–6 /Et₂AlCl exhibited enhanced activities. When activated with MAO or MMAO in toluene, these complexes showed relatively low activities but afforded polymers with ultra-high molecular weight (up to 3.30 × 10⁶ Da). 1–6 /Et₂AlCl also showed high activities in ethylene/1-hexene copolymerization at room temperature giving moderate molecular-weight polymers (6.5–11.4 × 10⁴ Da) with co-monomer incorporation being of 6.0 ~ 7.8%.     

Proton conductivity study on three CS/IL@fle-MOF membranes

The low-cost, high specific surface area and porosity, controlled pore size, and chemical properties of metal–organic framework (MOF) materials have attracted much attention in the exploration of proton conduction. The method of chemically modifying MOF structures or introducing conductive medium into the holes can effectively improve the proton conductivities of the materials. Here, the structural tunability of ionic liquid (IL) and flexible MOF (fle-MOF) materials are matched to give full play to the conductivity of IL, the framework support, and the microporous effect of MOFs, which achieves the synergistic effect of performance and expands the temperature range of proton transfer. Three kinds of CS/IL@fle-MOF membranes were prepared by combining three fle-MOFs with 1-carboxymethyl-3-methylimidazole (CMMIM) in different proportions to obtain 15 pieces of membranes. The comparative analyses show that CS/IL@fle-MOF membranes have excellent proton conduction performance at a wider temperature range (263–353 K) and lower relative humidity (75% RH). Among them, the proton conductivities of CS/CMMIM@MIL-88A-25% and CS/CMMIM@MIL-88B-125% are up to 1.33 and 1.42 S cm⁻¹ at 75% RH and 353 K, respectively; whereas those of CS/CMMIM@MIL-53(Fe)-75% and CS/CMMIM@MIL-88B-125% reach up to 2.1 × 10⁻³ and 1.28 × 10⁻³ S cm⁻¹ at 75% RH and 263 K, respectively. The E_a of CS/CMMIM@fle-MOFs is in the range of 0.1–0.5 eV, suggesting that the proton transport follows predominantly the typical Grotthuss transfer mechanism. The results of this study indicate that the CS/CMMIM@fle-MOF membranes combinations offer great potential for the design of composite porous proton-conducting materials.     

The chemical profile of active fraction of Kalimeris indica and its quantitative analysis

Kalimeris indica (L) Sch-Bip is a medicinal plant used by the Miao ethnic group in the Guizhou province of China. It is widely used as a fresh vegetable to treat colds, diarrhea and gastric ulcers. However, few studies have been conducted on the mechanism of its effect on colds, and its quality control. The anticomplement and antitussive activities of different polar extracts of K. indica were evaluated. Fifty-nine compounds, mainly including phenols and flavonoids, were identified in K. indica extract by ultra-high-performance liquid chromatography quadrupole time-of-flight tandem mass spectrometry. A method was established through ultra-high-performance liquid chromatography with a photodiode array to simultaneously determine the anticomplement and antitussive activity of five compounds in K. indica combining chemical identification with chemometrics for discrimination and quality assessment. Also, 3,5-dicaffeoylquinic acid and 4,5-dicaffeoylquinic acid exhibited significantly higher anticomplementary activity than the other three compounds. The quantitative data were further analyzed by principal component analysis and orthogonal partial least-squares discriminant analysis. Heatmap visualization was conducted to clarify the distribution of the major compounds in different geographical origins. Screening pharmacological activities by a combination of chemometrics and chemical identification might be an effective method for the quality control of K. indica.     

UPLC–ESI–Q-TOF–MS/MS analysis of anticancer fractions from Ophiocordyceps xuefengensis and Ophiocordyceps sinensis

Ophiocordyceps xuefengensis (O. xuefengensis), a new species of caterpillar fungus, has been identified as the sister taxon of Ophiocordyceps sinensis (O. sinensis). The aims of the present study are to evaluate the anticancer activity and to qualitatively analyze the potential bioactive chemical constituents of O. xuefengensis and O. sinensis, comparatively. An MTT assay was used to evaluate the in vitro anticancer activities of different fractions from O. xuefengensis and O. sinensis. The results show that ethyl acetate fractions of O. xuefengensis and O. sinensis have significant in vitro anticancer activity. These two bioactive fractions were analyzed by ultra-performance liquid chromatography–electrospray ionization with quadrupole–time of flight tandem mass spectrometry technology. A total of 82 compounds and 101 compounds were identified or tentatively characterized in the bioactive fractions of O. xuefengensis and O. sinensis, respectively. Among these compounds, 68 existed in both O. xuefengensis and O. sinensis. A total of 67 compounds were reported in O. xuefengensis and 8 compounds were reported in caterpillar fungus for the first time. This is the first detailed comparative analysis of the in vitro anticancer activity and chemical ingredients between O. xuefengensis and O. sinensis. The application of this work will provide reliable fundamental pharmacological substances for the use of O. xuefengensis by Yao people.     

烧结烟气脱硫脱硝用活性炭混合钢渣复合材料的光谱学分析

钢渣是冶金工业中产生的主要固体废弃物,其产量约为每年粗钢产量的15%~20%。由于技术的局限,导致我国钢渣利用率较低,仅为年钢渣产量的10%,同时加之管理制度的不健全,导致钢渣大量露天堆放,对土地资源、地下水源,以及空气质量形成严重影响。固体废弃物再利用是资源可持续发展的重要途径之一,钢渣的主要化学成分为CaO, SiO2, Al2O3, MgO, Fe2O3, MnO, f-CaO等。面对上述问题,利用冶金固体废弃物与活性炭开发一种价格低廉且性能优越的活性炭混合钢渣复合材料,既是冶金固体废弃物的高附加值利用与资源可持续发展的重要途径之一,也是大幅降低改性活性炭生产成本与提高经济效益的重要途径之一。该研究创新性以活性炭与钢渣为研究对象,利用钢渣中含有的金属氧化物对活性炭进行改性处理制备用于烧结烟气脱硫脱硝的活性炭混合钢渣复合材料,通过搭建实验反应装置对活性炭混合钢渣复合材料的脱硫脱硝性能进行测试。利用X射线荧光光谱仪(XRF)对钢渣的化学成分进行测试与分析,比表面积及孔径测定仪(BET)对活性炭混合钢渣复合材料的孔结构进行测试与分析,傅里叶变换红外光谱仪(FTIR)对钢渣的结构组成进行测试与分析,扫描电子显微镜(SEM)对活性炭混合钢渣复合材料的微观结构进行测试与分析,以揭示活性炭与钢渣制备活性炭混合钢渣复合材料的机理,以及活性炭混合钢渣复合材料对烧结烟气脱硫脱硝的机理。结果表明:当钢渣为电炉热泼渣、钢渣与活性炭质量比为2∶4、钢渣与活性炭细度为400目时,活性炭混合钢渣复合材料具有良好的脱硫脱硝性能与合理的经济性,即脱硫效率为100%、脱硝效率为58%。活性炭混合钢渣复合材料具有的多孔结构对SO2和NO进行有作用,钢渣中Fe2O3与MnO2促使活性炭官能团进行催化还原反应提高脱硫脱硝性能,其中吸附作用是主导与前提,催化还原反应是辅助与协同。以期为高附加值的钢渣利用提供新途径,实现钢铁企业以废治废、以废增效的目的。